Sentence examples of "частота вращения на валу" in Russian
С использованием блока питания соответствующей конструкции на испытательной станции измеряются крутящий момент ? [Н · м] и скорость вращения n [c-1] и рассчитывается входная мощность P1 [Вт] на валу компрессора или генератора.
Using a suitable design of power pack in the test station, the torque τ [N.m] and operating rotational speed n [s-1] are measured and the input power P1 [W] on the shaft of the compressor or generator is calculated.
частота вращения: приборы должны обеспечивать измерение частоты вращения двигателей, приводящих в действие компрессоры и вентиляторы конденсатора-испарителя, либо возможность расчета этой частоты, если ее прямое измерение невозможно;
Speed of rotation: Instruments shall be provided to measure the speed of rotation of the compressors and condenser and evaporator fans or to allow these speeds to be calculated where direct measurement is impractical.
Приборы для измерения крутящего момента и числа оборотов должны позволять проводить измерения мощности на валу в заданных пределах.
The instrumentation for torque and speed measurement shall allow the measurement of the shaft power within the given limits.
Для определения мощности на валу Р2 [Вт] стандартного или вспомогательного генератора путем электрического измерения необходимо учитывать коэффициент полезного действия таких автомобильных генераторов (обычно 24 В постоянного тока, 100 А- 150 А).
Regarding the shaft power P2 [W] of a standard or auxiliary alternator determined from electric measurement, the efficiency of such vehicle alternators has to be considered (usually 24 V dc, 100 A to 150 A).
Если транспортное средство не может достичь указанной выше частоты вращения, то целевая частота вращения двигателя должна быть на 5 % меньше максимально возможной частоты вращения для данного испытания в неподвижном состоянии.
If the vehicle cannot reach the engine speed as stated above, the target engine speed shall be 5 per cent below the maximum possible engine speed for that stationary test.
Высокая частота вращения nhi определяется исходя из расчета 70 % заявленной максимальной полезной мощности P (n) согласно пункту 8.2 добавления 1 к приложению 1.
The high speed nhi shall be determined by calculating 70 per cent of the declared maximum net power P (n), as determined in Annex 1, paragraph 8.2.
n95h- наибольшая частота вращения, при которой мощность составляет 95 % от максимальной мощности.
n95h is the highest speed where the power is 95 per cent of maximum power.
Это требование также применяется, в частности, к регулировке холостого хода [частота вращения и содержание окиси углерода (СО) в отработавших газах], устройству для запуска холодного двигателя и системе очистки отработавших газов.
This requirement also applies, in particular, to the idle settings (rotation speed and carbon monoxide (CO) content of the exhaust gases), to the cold start device and to the exhaust gas pollutant emission control system.
Точка холостого хода определяется как точка, в которой приведенный исходный крутящий момент составляет 0 % и приведенная исходная частота вращения- также 0 %.
An idle point is defined as a point having a normalized reference torque of 0 per cent and a normalized reference speed of 0 per cent.
Наименьшая частота вращения двигателя, соответствующая этому значению мощности по кривой мощности, обозначается как nlo.
The lowest engine speed where this power value occurs on the power curve is defined as nlo.
Это требование применяется также, в частности, к регулировке холостого хода (частота вращения и содержание оксида углерода в отработавших газах), устройству для запуска холодного двигателя и системам очистки отработавших газов.
This requirement also applies, in particular, to the settings for idling (rotation speed and carbon monoxide content of the exhaust gases), for the cold start device and for the exhaust gas cleaning system.
nhi- наибольшая частота вращения, при которой мощность составляет 70 % от максимальной мощности
nhi is the highest speed where the power is 70 per cent of maximum power.
npref- частота вращения двигателя, при которой максимальный интеграл крутящего момента составляет 51 % от полного интеграла
npref is the engine speed where the max. torque integral is 51 per cent of the whole integral
Наибольшая частота вращения двигателя, соответствующая этому значению мощности по кривой мощности, обозначается как nhi.
The highest engine speed where this power value occurs on the power curve is defined as nhi.
Частота вращения двигателя измеряется при помощи приборов, функционирующих с погрешностью не более ± 2 % при требующейся для проведения измерений частоте вращения.
The engine speed shall be measured with instrumentation having an accuracy of ± 2 per cent or better at the engine speeds required for the measurements being performed.
Examples of word usage in different contexts are provided solely for linguistic purposes, i.e. to study word usage in a sentence in one language and how they can be translated into another. All samples are automatically collected from a variety of publicly available open sources using bilingual search technologies.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
In this section, you can see how words and expressions are used in different contexts using examples of translations made by professionals. The Contexts section will help you learn English, German, Spanish and other languages. Here you can find examples with phrasal verbs and idioms in texts that vary in style and theme. Examples can be sorted by translations and topics.
Learn foreign languages, see the translation of millions of words and expressions, and use them in your e-mail communication.
Advert