Ejemplos del uso de "absolute wellhead pressure" en inglés
pp is the absolute pressure at venturi inlet, kPa
pp- абсолютное давление на входе трубки Вентури, кПа,
pp = absolute pressure at venturi inlet, kPa
pp = абсолютное давление на входе в трубку Вентури, кПа
Replace " but not more than 175 kPa (1.75 bar) (absolute pressure) " with " and a boiling point of more than 35°C ".
Заменить " но не более 175 кПа (1,75 бар) (абсолютное давление) " на " а температура кипения- более 35°С ".
The calculated flow-rate (given in m3/min at pump inlet, absolute pressure and temperature) can then be plotted versus a correlation function that is the value of a specific combination of pump parameters.
Значение рассчитанного расхода (в м3/мин. на входе в насос при абсолютном давлении и температуре) наносится затем на график зависимости расхода от корреляционной функции, которая является показателем конкретного сочетания параметров насоса.
Pv = absolute pressure at the venturi inlet (kPa).
Pv- абсолютное давление на выходном отверстии трубки Вентури (кПа).
Pp = absolute pressure at the inlet to the positive displacement pump in kPa;
Pp = абсолютное давление на входе нагнетательного поршневого насоса в кПа;
The calculated flow rate (in m3/s at pump inlet, absolute pressure and temperature) shall be plotted versus a correlation function which is the value of a specific combination of pump parameters.
Затем строится кривая рассчитанного расхода (выраженного в м3/с на входном отверстии насоса при абсолютном давлении и температуре) по отношению к функции корреляции, которая является показателем конкретного сочетания параметров насоса.
PDa: Absolute vapour pressure at filling temperature in kPa
PDa: Абсолютное давление паров при температуре наполнения в кПа
rp is the ratio of the SSV throat to inlet absolute static pressure =
rp- отношение давления на сужении SSV к абсолютному статистическому давлению на входе =
pp is the absolute outlet pressure at pump outlet, kPa
pp- абсолютное давление на выходе насоса, кПа
The airflow rate shall then be converted to pump flow (V0) in m3/rev at absolute pump inlet temperature and pressure as follows:
Затем расход воздуха преобразуется в расход насоса (V0) в м3/об при абсолютной температуре и давлении на входе насоса по следующей формуле:
PDa: Vapour pressure at absolute filling temperature in kPa
PDa: Абсолютное давление паров при температуре наполнения в кПа
The flow test results must be corrected to standard conditions: air pressure of 100 kPa absolute and temperature of 15°C.
Результаты измерения потока воздуха должны быть скорректированы до нормальных условий: абсолютное давление воздуха 100 кПа и температура 15°C.
Pressure transducers', capable of measuring absolute pressures at any point in the range 0 to 200 kPa and having both of the following characteristics:
Датчики давления, способные измерять абсолютное давление в любой точке в диапазоне от 0 до 200 кПа и имеющие обе указанные ниже характеристики: а.
Tanks intended for the carriage of liquids having a vapour pressure of not more than 110 kPa (1.1 bar) (absolute) at 50°C shall have a venting system and a safety device to prevent the contents from spilling out if the tank overturns; otherwise they shall conform to 6.8.2.2.7 or 6.8.2.2.8.
Цистерны, предназначенные для перевозки жидкостей, имеющих при 50°С давление насыщенных паров не более 110 кПа (1,1 бара) (абсолютное давление), должны оборудоваться вентиляционной системой и предохранительным устройством, препятствующим утечке содержимого из цистерны в случае ее опрокидывания; в противном случае они должны соответствовать требованиям пунктов 6.8.2.2.7 или 6.8.2.2.8.
Ref. [6.8.2.2.8 Replace “a vapour pressure of more than 175 kPa (1.75 bar) but not exceeding 300 kPa (3 bar) (absolute) at 50°C” with “a boiling point of not more than 35°C”.
[6.8.2.2.8 Заменить " имеющих при 50°С давление паров более 175 кПа (1,75 бар), но не более 300 кПа (3 бар) (абсолютное давление) " на " с температурой кипения не более 35°С ".
[6.8.2.2.8 Replace “a vapour pressure of more than 175 kPa (1.75 bar) but not exceeding 300 kPa (3 bar) (absolute) at 50°C” with “a boiling point of not more than 35°C”.
[6.8.2.2.8 Заменить " имеющих при 50°С давление паров более 175 кПа (1,75 бар), но не более 300 кПа (3 бар) (абсолютное давление) " на " с температурой кипения не более 35°С ".
Los ejemplos del uso de palabras en diferentes contextos se proporcionan únicamente con fines lingüísticos, es decir, para estudiar el uso de palabras en un idioma y sus opciones de traducción a otro. Están recopilados automáticamente de fuentes abiertas utilizando tecnología de búsqueda basada en datos bilingües. Si encuentras un error ortográfico o de puntuación en el original o en la traducción, utiliza la opción "Informar de un problema" o escríbenos.
En esta sección, puedes ver cómo se usan las palabras y expresiones en diferentes contextos con los ejemplos de traducciones realizadas por profesionales. La sección Contextos te ayudara a aprender inglés, alemán, español y otros idiomas. Aquí puedes encontrar ejemplos con las frases verbales, expresiones idiomáticas y palabras ambiguas en textos de diferentes estilos y temas.
Los ejemplos se pueden ordenar por traducciones y temas, y también se puede realizar una búsqueda más precisa en los ejemplos encontrados.
Publicidad