Usage examples of "brake control" in English with translation to Russian

<>
Simultaneous actuation of both service brake system controls, if so equipped, or of the single service brake control in the case of a service brake system that operates on all wheels. Одновременное приведение в действие обоих органов управления системы рабочего тормоза, если транспортное средство оборудовано таким образом, или одного органа управления рабочим тормозом в случае системы рабочего тормоза, воздействующей на все колеса.
to allow mechanical (including hydraulic, electrical or pneumatic) operation of the service brake control. это требуется для обеспечения механического (включая гидравлическое, электрическое или пневматическое) управления рабочим тормозом.
A discussion on brake control actuation force requirements for evaluating motorcycles equipped with ABS is provided in paragraph 5.2.7. Вопрос о требованиях в отношении приведения в действие органа тормозного управления для оценки мотоциклов, оборудованных АБС, освещен в пункте 5.2.7.
Annex 12- Appendix 4- Test report on the compatibility of the inertia brake control device, the transmission and the brakes on the trailer Приложение 12- Добавление 4: Протокол испытания в отношении совместимости устройства управления инерционного тормоза, приводного устройства и тормозов прицепа СОДЕРЖАНИЕ (продолжение)
For each stop, accelerate the vehicle to the test speed and then actuate the brake control under the conditions specified in this paragraph. Для каждой остановки транспортное средство разгоняется до испытательной скорости и затем приводится в действие тормозной орган управления в соответствии с условиями, указанными в настоящем пункте.
After a distance of ≥ 500 m, apply the averaged brake control force determined in the baseline test for the brake system being tested. После прохождения расстояния ? 500 м к органу тормозного управления прилагается среднее усилие, определенное в ходе контрольного испытания испытываемой тормозной системы.
A hot brake stop using the dry stop test- single brake control actuated, to measure the brake's performance after the heating procedure. Остановка с помощью нагретых тормозов по процедуре испытания на торможение на сухой поверхности- приведение в действие одного органа тормозного управления для измерения эффективности тормозов после выполнения процедуры разогрева.
After a distance of ≥ 500 m, apply the average brake control force determined in the baseline test for the brake system being tested. После прохождения расстояния ? 500 м к органу тормозного управления прилагается среднее усилие, определенное в ходе контрольного испытания испытываемой тормозной системы.
For each stop, accelerate the vehicle to the test speed and then apply the brake control (s) under the conditions specified in this paragraph. Для каждой остановки разогнать транспортное средство до испытательной скорости и затем привести в действие орган (органы) тормозного управления в соответствии с условиями, указанными в настоящем пункте.
For each stop, accelerate the vehicle to the test speed and then actuate the brake control (s) under the conditions specified in this paragraph. Для каждой остановки транспортное средство разгоняется до испытательной скорости и затем приводится (приводятся) в действие орган (органы) тормозного управления в соответствии с условиями, указанными в настоящем пункте.
For the first stop, accelerate the vehicle to the initial speed and then actuate the brake control under the conditions specified until the final speed is reached. Для первой остановки разогнать транспортное средство до начальной скорости и затем привести в действие орган тормозного управления в соответствии с указанными условиями, пока не будет достигнута конечная скорость.
Carry out the test set out in section 3. of this annex, (dry stop test- single brake control actuated) for each service brake system with the power assistance disabled. Испытание проводится в соответствии с предписаниями, содержащимися в разделе 3 настоящего приложения (испытание на торможение на сухой поверхности- приведение в действие одного органа тормозного управления), для каждой системы рабочего тормоза с отключенным усилителем.
For the revised proposal, in the case of separate service brake systems, each brake control shall be tested separately and capable of meeting the minimum brake performance for the single rear brake system. Согласно пересмотренному предложению, в случае раздельных систем рабочего тормоза каждый орган тормозного управления должен подвергаться испытанию отдельно и должен быть в состоянии обеспечить минимальную эффективность торможения для данной системы заднего тормоза.
For the revised proposal, in the case of separate service brake systems, each brake control must be tested separately and capable of meeting the minimum brake performance for the single rear brake system. Согласно пересмотренному предложению, в случае раздельных систем рабочего тормоза каждый орган тормозного управления должен подвергаться испытанию отдельно и должен быть в состоянии обеспечить минимальную эффективность торможения для данной системы заднего тормоза.
The latter requirement is made more objective by requiring that the motorcycle meet the deceleration rate for the dry stop test- single brake control actuated, as noted in the table in paragraph 4.3.3. Последнее предписание носит более объективный характер, поскольку оно предусматривает коэффициент замедления мотоцикла в ходе испытания на торможение на сухой поверхности с приведением в действие одного органа тормозного управления в соответствии с таблицей, содержащейся в пункте 4.3.3.
Accelerate the vehicle to the test speed, actuate the brake control under the conditions specified and record the control force required to achieve the vehicle braking performance specified in the table to paragraph 4.3.3. Транспортное средство разогнать до испытательной скорости, привести в действие орган тормозного управления в соответствии с указанными условиями и зарегистрировать усилие на органе управления, необходимое для достижения эффективности торможения транспортного средства, указанной в таблице, содержащейся в пункте 4.3.3.
As more test data becomes available, Contracting Parties may wish to consider setting an upper limit to the brake control actuation force in the gtr, or alternately, specifying such a limit in their respective national legislation, and с получением более подробных данных об испытаниях Договаривающиеся стороны, возможно, пожелают рассмотреть вопрос о введении в рамках гтп верхних пределов усилия, прилагаемого к органу тормозного управления, либо в противном случае об указании такого предела в своем соответствующем национальном законодательстве; и
With the ABS electrical system disabled, carry out the test set out in section 3. of this annex, (dry stop test- single brake control actuated) applying the conditions relevant to the brake system and vehicle being tested. после отключения электрической системы АБС проводится испытание, указанное в разделе 3 настоящего приложения (испытание на торможение на сухой поверхности- приведение в действие одного органа тормозного управления), при соблюдении условий, соответствующих испытываемым тормозным системам и транспортным средствам.
The first was based on the requirements in UNECE Regulation No. 78 in which minimum brake control actuation forces are specified, with the caveat that a higher force may be used if required to activate the ABS. Первая из них основывается на предписаниях Правил № 78 ЕЭК ООН, в которых указано минимальное усилие, прилагаемое к органу тормозного управления, с предупреждением о том, что может использоваться и большее усилие, если это требуется для приведения в действие АБС.
The national standards and regulations have slightly different brake control input force limits, and in the case of a hand operated control lever, there is also a discrepancy as to the location of application of the input force. Национальные стандарты и правила содержат несколько отличающиеся между собой предельные значения усилия, прилагаемого на органы тормозного управления, а в случае ручного рычага тормозного управления имеются расхождения и в отношении места приложения усилия.
Examples of word usage in different contexts are provided solely for linguistic purposes, i.e. to study word usage in a sentence in one language and how they can be translated into another. All samples are automatically collected from a variety of publicly available open sources using bilingual search technologies.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.

What is translation in context on PROMT.One

The “Contexts” section on PROMT.One is your translation-in-context tool that helps you find real examples of how words and phrases are used. Just enter a word and the service will show its translation in context — sentences from bilingual sources where this word is used together with its translation into the target language. This helps you understand subtle shades of meaning and correct usage in speech, whether it is a rare term or a common everyday phrase.

Millions of usage examples from real texts

Millions of translation examples are collected automatically from already translated texts: documents, websites, books, movie dialogues and more. Thanks to this, you can see a word in different situations — from formal business style to everyday colloquial speech. For convenience, the results can be filtered by a specific translation or topic, and you can also search within the examples found to quickly focus on the context you need.

How translation in context helps you learn a language

By using the “Contexts” section, you can effectively expand your vocabulary. The service clearly shows how idioms, phrasal verbs and polysemantic words are translated in different contexts. This makes language learning easier: you remember new words together with their real usage and immediately see correct translations in authentic, living language. Take advantage of context-based translation on PROMT.One — learning a language becomes easier and more engaging!