Sentence examples of "Осадки" in Russian with translation "draught"

<>
LF- длина корпуса судна, измеренная на уровне предельной осадки судна (м). LF = length of the hull, measured at maximum draught (m).
L = максимальная длина корпуса судна, измеренная на уровне предельной осадки судна (м). L = maximum length of the hull, measured at maximum draught (m).
Увеличение максимальной осадки (с 1,3 м) на реке Припять (E 40) от Стахова до устья. Upgrading the maximum draught (from 1.3 m) on the Pripyat River (E 40) from Stakhovo to the mouth.
«Ширина по ватерлинии (BWL)»- ширина корпуса в м ‚ измеряемая от внешних кромок бортовой обшивки на уровне максимальной осадки. " breadth of waterline (BWL) ": breadth of the hull in m, measured from the outside of the side plating at the maximum draught line.
Базовое знание технических правил, касающихся остойчивости пассажирских судов в случае повреждения, деления на водонепроницаемые отсеки, плоскости максимальной осадки. Basic knowledge of technical regulations on: the stability of passenger vessels in case of damage, division into watertight compartments, plane of maximum draught.
В носовой части судна пол не должен быть более чем на 1,20 м ниже плоскости предельной осадки. In the fore section of the vessel no floor shall be more than 1.20 m below the plane of maximum draught.
Увеличение осадки (с 2,5 м) и высоты прохода под мостами (с 5,76 м) на реке Уазе от Крейя до Компьеня. Upgrading the draught (from 2.5 m) and height under bridges (from 5.76 m) on the Oise River from Creil to Compiègne
4-3.1 Плоскость максимальной осадки определяется таким образом, чтобы выполнялись требования как в отношении надводного борта, так и в отношении расстояния безопасности. 4-3.1 The maximum draught level shall be so determined that both the freeboard requirements and the safety-distance requirements are observed.
Графически это можно изобразить в виде прямоугольной зоны, образованной значениями максимальной и минимальной осадки как судна, нанесшего удар, так и судна, подвергшегося удару. This can be depicted graphically through a rectangular area which is enclosed by the values of the maximum and minimum draught of both striking and struck vessel.
«Надводный борт»- расстояние по вертикали, измеренное на миделе от верхней кромки палубной линии, определенной в пункте 4-4.1.1, до плоскости максимальной осадки. “freeboard”: is the vertical distance measured amidships between the upper edge of the deck line as defined in paragraph 4-4.1.1 and the maximum draught level.
Планирование рейса включает в себя планирование погрузочных работ и обеспечение надлежащей осадки судна, а также планирование ETA и возможной догрузки и разгрузки в ходе рейса. Voyage planning comprises the planning of the loading and the draught of the vessel, as well as the planning of the ETA and of possible loadings or unloadings during the voyage.
1-бис-2.1.3 проверки наличия обозначений, предназначенных для идентификации судна и контроля, проводимого речной полицией, в частности указателя осадки, указания дедвейта и регистрационного номера. 1bis-2.1.3 ensure the attachment of the facilities determined for the identification of the vessel and the control by the shipping police, especially draught indicators, deadweight specification and registration number.
В последнем случае водоизмещение порожнем должно быть проверено путем соответствующего испытания, в результате которого допускается разница + 5 % между массой, определенной путем расчетов, и водоизмещением, вычисленным на основе значений осадки. In the latter case the lightweight of the vessel shall be checked by means of a lightweight test with a tolerance limit of ± 5 % between the mass determined by calculation and the displacement determined by the draught readings.
после пункта 76 включается пункт 76а: " 76а. " общая осадка (ТОА) "- вертикальное расстояние в метрах между самой нижней точкой корпуса, включая киль или иные стационарно установленные элементы, и линией максимальной осадки "; Point 76a is inserted after Point 76: “76a.” “draught overall (TOA)”: the vertical distance in m between the lowest point of the hull including the keel or other fixed attachments and the maximum draught line; "
Например, для случая столкновения 1 весовой коэффициент равен соотношению между треугольной нижней правой зоной прямоугольника и зоной прямоугольника между минимальным и максимальным значениями осадки судна, нанесшего удар, и судна, подвергшегося удару. For example, for collision case 1 the weighting factor equals the ratio between the triangular lower right area of the rectangle, and the area of the rectangle between minimum and maximum draughts of striking and struck vessels.
В последнем случае водоизмещение порожнем должно быть проверено путем соответствующего испытания, в результате которого допускается разница не более ± 5 % между массой, определенной путем расчетов, и водоизмещением, вычисленным на основе значений осадки. In the latter case the lightweight shall be checked by means of a lightweight test with a resulting difference of not more than ± 5 % between the mass determined by the calculation and the displacement determined by the draught readings.
Определение мест удара в вертикальном направлении зависит от различий в осадке между судном, нанесшим удар, и судном, подвергшимся удару, которые ограничены значениями максимальной и минимальной осадки обоих судов и конструкции судна, подвергшегося удару. The determination of the collision locations in the vertical direction depends on the draught differences between striking and struck vessel, which is limited by the maximum and minimum draughts of both vessels and the construction of the struck vessel.
Междудонное пространство, топливные цистерны, балластные и прочие цистерны в зависимости от того, должны ли эти емкости в соответствии с их назначением считаться заполненными или порожними, когда судно погружено по плоскость наибольшей осадки 0 или 95 % Double bottoms, fuel bunkers, ballast tanks and other tanks, depending on whether, according to their intended purpose, they are to be assumed to be full or empty for the vessel floating at the plane of maximum draught 0 or 95 %
1/Осадка (d) и минимальная высота прохода под мостами (H), приведенные в таблице 1, указываются по отношению к низкому судоходному уровню воды (НСУВ) для осадки и самому высокому судоходному уровню воды (ВСУВ) для высоты прохода под мостами. 1/The draught (d) and the minimum height under bridges (H) indicated in Table 1 are given in relation to the Low Navigable Water Level (LNWL) for the draught and the Highest Navigable Water Level (HNWL) for the height under bridges.
15-4.3 Плоскость максимальной осадки должна определяться таким образом, чтобы соблюдались расстояние безопасности в соответствии с пунктом 15-4.1 и величина надводного борта в соответствии с пунктами 15-4.2, 15-2 и 15-3. 15-4.3 The maximum draught level is to be set so as to ensure compliance with the safety clearance according to 15-4.1, and the freeboard according to 15-4.2, 15-2 and 15-3.
Examples of word usage in different contexts are provided solely for linguistic purposes, i.e. to study word usage in a sentence in one language and how they can be translated into another. All samples are automatically collected from a variety of publicly available open sources using bilingual search technologies.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.

What is translation in context on PROMT.One

The “Contexts” section on PROMT.One is your translation-in-context tool that helps you find real examples of how words and phrases are used. Just enter a word and the service will show its translation in context — sentences from bilingual sources where this word is used together with its translation into the target language. This helps you understand subtle shades of meaning and correct usage in speech, whether it is a rare term or a common everyday phrase.

Millions of usage examples from real texts

Millions of translation examples are collected automatically from already translated texts: documents, websites, books, movie dialogues and more. Thanks to this, you can see a word in different situations — from formal business style to everyday colloquial speech. For convenience, the results can be filtered by a specific translation or topic, and you can also search within the examples found to quickly focus on the context you need.

How translation in context helps you learn a language

By using the “Contexts” section, you can effectively expand your vocabulary. The service clearly shows how idioms, phrasal verbs and polysemantic words are translated in different contexts. This makes language learning easier: you remember new words together with their real usage and immediately see correct translations in authentic, living language. Take advantage of context-based translation on PROMT.One — learning a language becomes easier and more engaging!