Sentence examples of "вал" in Russian with translation "shaft"

<>
Вал, однако, может быть соединен с гидродинамическим подшипником. The shaft may, however, have a hydrodynamic bearing attached.
У нас будет железный лестницы вниз на главный вал. We will have iron ladders down the main shaft.
Скрестим пальцы, чтобы нам не вырвало приводной вал через днище машины. Fingers crossed it don't yank the drive shaft through the floor.
Оба котла из строя не вывести, так что, если хотите остановить их, должны повредить вал. Not gonna be able to take out both boilers, so if you want to kill her, gotta damage the shaft.
Ступица сменного рулевого колеса насаживается на жесткий вал и подвергается воздействию испытательной статической нагрузки 70 даН ± 0,5 даН, прилагаемой по касательной к ободу рулевого колеса. The replacement steering wheel is mounted with its hub on a rigid shaft and subjected statically to a test load of 70 daN ± 0.5 daN applied tangentially to the steering wheel rim.
Противоугонное устройство отключается, а рулевой вал поворачивается до такого положения, которое предотвращает включение противоугонного устройства, если данный тип устройства не предусматривает возможность блокировки рулевого управления в любом положении. The protective device shall be deactivated and the steering shaft shall be rotated to a position which prevents engagement of the protective device, unless it is of the type which permits locking in any position of the steering.
Ось обычно представляет собой вал из закаленной стали с одним концом в форме полусферы, и со средствами подсоединения к нижней крышке, описанной в разделе 22.1 (е), на другом. The pivot is normally a hardened steel shaft with a hemisphere at one end with a means of attachment to the bottom cap described in Section 22.1 (e) at the other.
Фактический тормозной момент измеряют, когда вал динамометрического стенда приходит в движение, после чего вычисляется сила торможения соответствующей оси с использованием радиуса шины, указанного в пункте 2.2.1.5.1. Measure the output torque at the brake in the moment the dyno shaft begins to move and calculate corresponding axle braking force using the tyre radius as determined under paragraph 2.2.1.5.1.
Устройство для предотвращения несанкционированного использования отключается, а рулевой вал поворачивается до такого положения, которое предотвращает включение устройства для предотвращения несанкционированного использования, если только данный тип устройства не предусматривает возможность блокировки в любом положении рулевого управления. The device to prevent unauthorized use shall be deactivated and the steering shaft shall be rotated to a position which prevents engagement of the device to prevent unauthorized use, unless it is of the type which permits locking in any position of the steering.
под " характеристическим коэффициентом транспортного средства "- цифровая характеристика, показывающая величину выходного сигнала, который создается тем элементом транспортного средства, который соединяет его с контрольным устройством (вторичный вал или ось коробки передач), когда транспортное средство проходит расстояние в один измеренный километр при нормальных условиях испытания. “characteristic coefficient of the vehicle” means the numerical characteristic giving the value of the output signal emitted by the part of the vehicle linking it with the control device (gearbox output shaft or axle) while the vehicle travels a distance of one measured kilometre under normal test conditions.
Капитан, в машинном отделении небольшая течь из сальников ведущего вала. Captain, engine room reports minor flooding from shaft seals and brine pump.
Передаточное число 1 = первичное передаточное число (отношение числа оборотов двигателя к скорости вращения ведущего вала коробки передач). Ratio 1 = primary ratio (ratio of engine speed to rotational speed of primary gearbox shaft).
5-2.6 Если не предусмотрена возможность отсоединения гребных валов, то они должны быть оборудованы надлежащими стопорными устройствами. 5-2.6 If the propeller shafts cannot be disconnected, they shall be equipped with suitable blocking devices.
Системы передачи мощности трансмиссионным валом, включающие компоненты из «композиционных материалов» и способные осуществлять передачу мощности более 2 МВт; Power transmission shaft systems, incorporating " composite " material components, capable of transmitting more than 2 MW;
Приборы для измерения крутящего момента и числа оборотов должны позволять проводить измерения мощности на валу в заданных пределах. The instrumentation for torque and speed measurement shall allow the measurement of the shaft power within the given limits.
Передаточное число 3 = передаточное число конечной передачи (отношение скорости вращения выходного вала коробки передач к скорости вращения ведомых колес). Ratio 3 = final drive ratio (ratio of rotational speed of gearbox output shaft to rotational speed of driven wheels).
4-2.2.1.3 Если через водонепроницаемые переборки и палубы проходят валы, трубопроводы, шпигаты, электрические кабели и т.п., то должны приниматься меры, предотвращающие нарушение водонепроницаемости переборок или палуб. 4-2.2.1.3 Where shafts, pipes, scuppers, electric cables, etc., are carried through watertight subdivisions, arrangements shall be made to avoid impairing the watertight integrity of the bulkheads or decks.
3-4.2.1.3 Если через водонепроницаемые переборки и палубы проходят валы, трубопроводы, шпигаты, электрические кабели и т.п., то должны приниматься меры, предотвращающие нарушение водонепроницаемости переборок или палуб. 3-4.2.1.3 Where shafts, pipes, scuppers, electric cables, etc., are carried through watertight subdivisions, arrangements shall be made to avoid impairing the watertight integrity of the bulkheads or decks.
С использованием блока питания соответствующей конструкции на испытательной станции измеряются крутящий момент ? [Н · м] и скорость вращения n [c-1] и рассчитывается входная мощность P1 [Вт] на валу компрессора или генератора. Using a suitable design of power pack in the test station, the torque τ [N.m] and operating rotational speed n [s-1] are measured and the input power P1 [W] on the shaft of the compressor or generator is calculated.
Для определения мощности на валу Р2 [Вт] стандартного или вспомогательного генератора путем электрического измерения необходимо учитывать коэффициент полезного действия таких автомобильных генераторов (обычно 24 В постоянного тока, 100 А- 150 А). Regarding the shaft power P2 [W] of a standard or auxiliary alternator determined from electric measurement, the efficiency of such vehicle alternators has to be considered (usually 24 V dc, 100 A to 150 A).
Examples of word usage in different contexts are provided solely for linguistic purposes, i.e. to study word usage in a sentence in one language and how they can be translated into another. All samples are automatically collected from a variety of publicly available open sources using bilingual search technologies.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.

In this section, you can see how words and expressions are used in different contexts using examples of translations made by professionals. The Contexts section will help you learn English, German, Spanish and other languages. Here you can find examples with phrasal verbs and idioms in texts that vary in style and theme. Examples can be sorted by translations and topics.

Learn foreign languages, see the translation of millions of words and expressions, and use them in your e-mail communication.