Beispiele für die Verwendung von "Покрытие" im Russischen mit Übersetzung "surface"

<>
Покрытие основных и проселочных дорог не выдерживает такие повышенные нагрузки. Surface of main and country roads fail to bear such increased loads.
Покрытие приобретает свои требуемые характеристики не ранее, чем через четыре недели после строительства. The surface will achieve its required characteristics not earlier than four weeks after construction.
Со временем, эти тоненькие ниточки формируются в слои и создают покрытие на поверхности жидкости. Over time, these tiny threads form in the liquid into layers and produce a mat on the surface.
Внутреннее покрытие может выполняться из стекловолокна типа C в соответствии со стандартом ISO 2078: 1993. For the internal surface liner, glass fibres of type C according to ISO 2078: 1993 may be used.
Однако коэффициент звукопоглощения должен измеряться только в том случае, если покрытие не отвечает требованию в отношении пористости. However, sound absorption needs to be measured only if the surface fails to comply with the voids requirement.
Участок для проведения измерений должен быть горизонтальным; испытательное покрытие для проведения всех измерений должно быть сухим и чистым. The measuring section must be level; the test surface must be dry and clean for all measurements.
Рекомендуется, чтобы цвет стен туннелей был ярким и чтобы их поверхность имела невоспламеняющееся покрытие и легко очищалась (РП). It is recommended that the colour of tunnel walls be bright and that their surface be non-flammable and easy to clean (RP).
41 311 СО01: Поверхность трюмов должна иметь такое покрытие или должна быть так обработана, чтобы она была трудновоспламеняющейся и не могла пропитаться веществами груза. 41 311 CO01: The surfaces of holds shall be coated or lined such that they are not readily flammable and not liable to impregnation by the cargo.
Платформа должна иметь бортики высотой не менее 0,05 м, предотвращающие сползание кресла-коляски с инвалидом в процессе подъема (опускания), а также покрытие, препятствующее проскальзыванию колес КК. The platform should have a raised edge at least 0.05 m high, preventing wheelchairs with disabled persons from sliding during the lifting or lowering process, and also a non-skid surface for wheelchair wheels.
За исключением испытания АБС на использование сцепления и испытания на остановку при переходе с покрытия с низким коэффициентом трения на покрытие с высоким коэффициентом трения, Договаривающиеся стороны согласились принять- после пересмотра и уточнения отдельных положений- остальные процедуры испытаний АБС и требования к их эффективности торможения. With the exception of the ABS adhesion utilization test and the low-friction surface to high-friction surface transition stop, the Contracting Parties agreed to adopt, with selected revisions and clarifications, the remaining ABS test procedures and performance requirements.
11-7.2 Ширина трапов должна составлять не менее 0,60 м; глубина ступенек должна составлять не менее 0,15 м, а расстояние между двумя ступеньками- не более 0,3 м; поверхность ступенек должна иметь противоскользящее покрытие; трапы, имеющие более трех ступенек, должны быть оборудованы поручнями. 11-7.2 Stairs shall be not less than 0.60 m wide; steps shall be not less than 0.15 m deep and not more than 0.3 m high; steps shall have non-slip surfaces and stairs with more than three steps shall be fitted with hand-rails.
Z-7.2 Ширина трапов должна составлять не менее 0,60 м; глубина ступенек должна составлять не менее 0,15 м, а расстояние между двумя ступеньками- не более 0,3 м; поверхность ступенек должна иметь противоскользящее покрытие; трапы, имеющие более трех ступенек, должны быть оборудованы поручнями. Z-7.2 Stairs shall be not less than 0.60 m wide; steps shall be not less than 0.15 m deep and not more than 0.3 m high/; steps shall have non-slip surfaces and stairs with more than three steps shall be fitted with hand-rails.
" Определение обеих поверхностей Si и Sе осуществляется с учетом особенностей конструкции кузова или таких неровностей поверхности, как фаски, надколенные дуги и аналогичные элементы, и эти особенности или неровности учитываются и отмечаются в соответствующей рубрике протоколов испытаний; однако если кузов имеет покрытие типа гофрированного листа, то искомой поверхностью является прямая поверхность этого покрытия, а не ее развертка ". “In determining the two surface areas Si and Se, structural peculiarities and surface irregularities of the body, such as chamfers, wheel-arches and similar features, shall be taken into account and shall be noted under the appropriate heading in test reports; however, if the body is covered with corrugated sheet metal the area considered shall be that of the plane surface occupied, not that of the developed corrugated surface.”.
Определение обеих поверхностей Si и Sе осуществляется с учетом особенностей конструкции кузова или неровностей поверхности, таких как фаски, надколенные дуги и аналогичные элементы, и эти особенности или неровности учитываются и отмечаются в соответствующей рубрике протоколов испытаний; однако, если кузов имеет покрытие типа гофрированного листа, то искомой поверхностью является прямая поверхность этого покрытия, а не ее развертка. In determining the two surface areas Si and Se, structural peculiarities and surface irregularities of the body, such as chamfers, wheel-arches and similar features, shall be taken into account and shall be noted under the appropriate heading in test reports; however, if the body is covered with corrugated sheet metal the area considered shall be that of the plane surface occupied, not that of the developed corrugated surface.
Z-7.2 Ширина трапов должна составлять не менее 0,60 м, полезная ширина между поручнями- по меньшей мере 0,60 м; глубина ступенек должна составлять не менее 0,15 м, а расстояние между двумя ступеньками- не более 0,3 м39; поверхность ступенек должна иметь противоскользящее покрытие; трапы, имеющие более четырех трех ступенек, должны быть оборудованы поручнями. Z-7.2 Stairs shall be not less than 0.60 m wide and the usable width between hand-rails shall be not less than 0.60 m; steps shall be not less than 0.15 m high deep and not more than 0.3 m high/; steps shall have non-slip surfaces and stairs with more than four three steps shall be fitted with hand-rails.
«Z-7.2 Ширина наклонных трапов должна составлять не менее 0,6 м; глубина ступенек должна составлять не менее 0,15 м, а расстояние между двумя ступеньками- не более 0,3 м, при этом должно обеспечиваться одинаковое расстояние между ступеньками по всей длине трапа; поверхность ступенек должна иметь противоскользящее покрытие; трапы, имеющие более трех ступенек, должны быть оборудованы поручнями. “Z-7.2 Inclined stairs shall be not less than 0.6 m wide; steps shall be not less than 0.15 m deep and not more than 0.3 m high, and the pitch of the stairs shall be constant throughout their length; steps shall have non-slip surfaces; stairs with more than three steps shall be fitted with hand-rails.
PR = общая нормальная статическая реакция дорожного покрытия на колеса прицепа. PR = total normal static reaction of road surface on wheels of trailer.
С покрытия должны удаляться мусор и пыль, которые могут существенно уменьшить эффективную глубину текстуры. Loose debris or dust, which could significantly reduce the effective texture depth must be removed from the surface.
Дорога сейчас с гравийным покрытием, в режиме "Гравий", Evo выпускает когти и цепляется за дорогу. The road was now a loose surface, but in gravel mode, the Evo got its claws out and clung on.
Указанные размеры относятся к поверхности до ее покрытия материалом твердостью менее 50 единиц по Шору (А). The dimensions specified refer to the surface before the addition of material of less than 50 shore A hardness.
Beispiele für den Wortgebrauch in verschiedenen Kontexten werden ausschließlich zu linguistischen Zwecken bereitgestellt, d. h. um den Wortgebrauch in einer Sprache und Varianten ihrer Übersetzung in eine andere zu untersuchen. Alle Beispiele werden automatisch aus offenen Quellen mit Hilfe einer zweisprachigen Suchtechnologie gesammelt. Wenn Sie einen Rechtschreib-, Zeichensetzungs- oder anderen Fehler im Original oder in der Übersetzung finden, nutzen Sie die Option „Problem melden“ oder schreiben Sie uns.

Was ist Übersetzung im Kontext auf PROMT.One?

Der Bereich „Kontexte“ auf PROMT.One ist Ihr Tool für Übersetzung im Kontext und hilft Ihnen, echte Beispiele für die Verwendung von Wörtern und Ausdrücken zu finden. Geben Sie einfach ein Wort ein, und der Dienst zeigt Ihnen die Übersetzung im Kontext – Sätze aus zweisprachigen Quellen, in denen dieses Wort zusammen mit seiner Übersetzung in die Zielsprache vorkommt. So verstehen Sie Bedeutungsnuancen besser und sehen, wie das Wort korrekt verwendet wird – ganz gleich, ob es sich um einen seltenen Fachbegriff oder eine gängige Alltagsformulierung handelt.

Millionen von Verwendungsbeispielen aus echten Texten

Millionen von Übersetzungsbeispielen werden automatisch aus bereits übersetzten Texten gesammelt: aus Dokumenten, Websites, Büchern, Filmdialogen und vielem mehr. Dadurch sehen Sie ein Wort in ganz unterschiedlichen Situationen – vom formell-geschäftlichen Stil bis hin zur Umgangssprache. Zur besseren Übersicht können Sie die Ergebnisse nach einer bestimmten Übersetzung oder nach Thema filtern und zusätzlich in den gefundenen Beispielen suchen, um den benötigten Kontext schnell zu finden.

Wie Übersetzung im Kontext beim Sprachenlernen hilft

Wenn Sie den Bereich „Kontexte“ nutzen, erweitern Sie Ihren Wortschatz besonders effektiv. Der Service zeigt anschaulich, wie Redewendungen, Verbverbindungen und mehrdeutige Wörter in verschiedenen Zusammenhängen übersetzt werden. So wird das Sprachenlernen einfacher: Sie merken sich neue Wörter zusammen mit ihrem tatsächlichen Gebrauch und sehen sofort eine korrekte Übersetzung in einer lebendigen, authentischen Sprache. Nutzen Sie die Möglichkeiten der Übersetzung im Kontext auf PROMT.One – so macht Sprachenlernen noch mehr Spaß!